Install your BioMatch backweights

Use your current BioMatch Report to fit the recommended backweight to each club. Keep the report beside you as you work.

Download A4 PDF

Download US Letter PDF

Watch the step-by-step installation guide

Read the video transcript

Let's install your BioMatch backweights. Keep your current report beside you, and work on one club at a time.

First, match each backweight to the recommendation for that club. A zero gram recommendation means no backweight is needed. Check your report before you begin.

Have your backweights, Shaft Access Tool, a suitable tool handle, and the supplied four millimetre hex key ready. If you're unsure about fitting, a club fitter can help.

To open the end of the grip, fit the Shaft Access Tool into a suitable handle or electric screwdriver. Place its centre rod in the grip's vent hole. Keep the club secure and your hands clear of the cutting edge. Press while rotating to cut the opening.

Pull the centre rod to remove the rubber plug from the tool. Carefully clear any excess grip tape from the shaft opening using pliers or a screwdriver.

Next, insert the recommended backweight through the opening. If the brass rod has a rubber centralizer, rotate the weight gently to help it pass through.

Squeeze the plastic sleeve as you insert the weight fully. If the sleeve is too tight, loosen its screw slightly. Do not force the weight.

With the weight fully inserted, tighten its screw using the supplied four millimetre hex key until it is secure. Check that the weight does not move before using the club.

Repeat for the remaining clubs, checking each recommendation against your report. Before playing, check that every installed weight is secure.

If a weight will not fit or cannot be secured, stop and contact Rational Golf or a club fitter before modifying a weight or shaft.

You can find the printable installation guide at rational-golf dot com, under backweight installation. Keep it with your BioMatch report for reference.

BioMatch. One swing for all your clubs. Rational Golf. Results Driven by Science.

Before you start

  • A 0 g recommendation means no backweight is needed.
  • Our backweights come in 6-100 g sizes, in 2 g increments. Review grouping options and any warnings for recommendations above 40 g before ordering or fitting.
  • Have your backweights, Shaft Access Tool, a suitable tool handle and the supplied 4 mm hex key ready. If you are unsure about fitting, ask a club fitter for help.
  1. Match each weight to its club

    Lay out the clubs and backweights and check each weight against the recommendation in your report. Work on one club at a time.

  2. Open the end of the grip

    Fit the Shaft Access Tool into a screwdriver handle or suitable drill or electric screwdriver. Place its center rod in the vent hole at the end of the grip. Press while rotating to cut the opening. Keep the club secure and your hands clear of the cutting edge.

  3. Clear the opening

    Pull the center rod to remove the rubber plug from the tool. Carefully remove any excess grip tape inside the shaft opening with pliers or a screwdriver.

  4. Insert the backweight

    Push the weight through the opening in the grip. If it has a rubber centralizer on the brass rod, rotate the weight to help the centralizer pass through. Squeeze the plastic sleeve while inserting it fully. If the sleeve is too tight, loosen its screw slightly. Do not force a weight that does not fit.

  5. Secure the weight

    With the weight fully inserted, tighten the screw using the supplied 4 mm hex key until the weight is secure. Check that it does not move before using the club.

  6. Repeat and check

    Repeat for each club that needs a backweight, checking the report each time. Keep your report for reference and check that every installed weight is secure before playing.

If a weight does not fit

Stop if a weight will not fit or cannot be secured. Contact Rational Golf or a club fitter for fitting advice before modifying a weight or shaft.

Contact Rational Golf for fitting help

Watch the backweight installation video on YouTube (opens a new tab)